Recent Jobs For Summit Environmental Solutions

Customer Photo Solutions Provided
Sarah C.
Manassas, VA
December 3, 2021

Remove old blown/batted fiberglass insulation and animal feces. Sterifab entire attic space to disinfect. Install baffles at the soffit lines and around the entry point. Air seal gaps and conduit lines with spray foam insulation. Install can light covers over the recess lights for better energy efficiency. Check the wires for any damage. If major damage is found during installation client will be notified. Blow in new cellulose insulation to R49 (14 inches). Remove old attic fans and replace with new attic fans. Install roof vent guards over the attic fans to prevent entry of animals into the attic space.

Austin F.
Fredericksburg, VA
December 2, 2021

Remove section of shingles on backside of home close to the rain diverter. Install new ice/water shield and light grey architectural shingles. Shingles will not fully match existing due to age. Replace the rain diverter with a new one. Remove siding 1 foot up along the entire shed roof and install tyvek and seam tape to seal. Seal along the top and bottom edge of the flashing. Seal the exposed nails on the flashing. Reinstall the siding after work is complete.

Ross E.
Fairfax, VA
December 1, 2021

Remove all insulation. Sanitize the attic with mildew and fungus killing agent. Install baffles to keep insulation in proper place. Weatherstrip and air seal attic hatch. Air seal all cracks and penetrations from wiring, plumbing, and hvac, etc. Blow in all new cellulose insulation to a depth of 14”, R49. Install covers over recessed lights, ceiling fan openings and bath fans.

Justin B.
Stafford, VA
November 30, 2021

In two lower attics with access points through the knee walls blow in new cellulose insulation to reach levels of R49 (14 inches).

Kishla A.
Alexandria, VA
November 24, 2021

In the rear attic space remove the batted/blown in fiber glass. Sterifab to disinfect. Air seal gaps and conduit lines. Include removing the accessible blown in insulation on the edges of the main attic space. Blow in new cellulose insulation to R49 (14 inches). Some areas will have less due to floor to roof clearance. Include baffles at soffit lines where needed. Remove the plywood boards carefully and place to the side. Remove the blown in insulation. Air seal the gaps and conduit lines with spray foam. Blow in new cellulose insulation level with the floor joists. Re install the existing floor boards as best as possible. Install radiant barrier along all the roof rafters to radiate the heat away from the attic. Replace the attic fan motor and thermostat that is wall mounted on the gable vent. Remove hard duct lines for two bathroom fans located in rear attic space. Install new insulated 4 inch duct lines. Install new exhaust vents on the out side of the home and attach the new flex lines. Includes bird guards to prevent entry of birds.

Tracy F.
Stafford, VA
November 24, 2021

Remove shingles and debris on backside of roof only. Check the plywood for damage and replace if needed. Install new synthetic underlayment, ice/water shield, new shingled ridge vent, roof boots, 750 vents, drip edge, and shingles to match front side shingles as best as possible. (Tamko three tab rustic black) Two new 223 vents with dampers will be installed in place of one of the 750 vents indicated by the technician. Bathroom exhaust pipes will be re routed to their designated 223 vents with new insulated flex lines.

David C.
Arlington, VA
November 22, 2021

Demo old batted insulation in main attic. Blow in cellulose to achieve R38 insulation. Add baffles around hatch entry point. Replace damaged entry hatch with PVC hatch, weather stripping and foam board. Apply thermax foam board over existing batted, spray foam the wedge area where there is no insulation present. Spot spray foam area to air seal. Right rear knee wall area: Add thermax and weather stripping on hatch door, both sides of knee wall with spot spray foam to air seal knee wall. Install thermax left and right of built in cabinet, air seal. Air seal and insulation rear of cabinet with 2 inches of closed cell foam. Add thermax and weather stripping to hatch door.

Joel T.
Woodbridge, VA
November 19, 2021

Supply trunk in garage attic is leaking some air and condensation was noted in places. Apply closed cell foam to 20 LF of supply duct to air seal and insulate. In cavity where supply and return trunks pass into living space plus area outside of the chase, apply cellulose to insulate areas. R38 when complete

Elizabeth H.
Arlington, VA
November 18, 2021

Install bathroom vents and fans in both bathrooms, these are to vent through the roof and one roof penetration. One will be operated by a switch which turns on the light and the fan at the same time, the other will have a separate switch. Broan quiet fans to be installed.

Frank T.
Stafford, VA
November 18, 2021

Remove damaged section of shingles and plywood. Install new plywood, 2x4, and shingles to match existing as best as possible. Tamko three tab antique slate.

Cory S.
Fredericksburg, VA
November 17, 2021

Clean out all debris from the gutters. Install Evelyn’s leaf solutions on all the gutters on the home. Will be secured to the lip of the gutter. Ends of the leaf solutions will be capped with white metal.

Timothy C.
Fredericksburg, VA
November 17, 2021

Remove section of the ridge vent and two sections of the shingles and the plywood. Install a new metal ridge vent on indicated section to include the new plywood, ice/water shield, and shingles to match existing three tab as best as possible.

Virginia M.
Quantico, VA
November 16, 2021

Existing roof past end of life. Some damaged decking noted as well. Tarp covering portion of roof. Ventilation is non existent and roof fan is non functioning. Tear off existing shingles and underlayment. Remove roof fan and discard. Inspect and replace up to 5 sheets of decking. Will need to verify decking or 1 x boards. Install 15# roofing felt. Install drip edge on all edges; includes rake and around reverse gable at entry point. Install ice and water shield. Two chimneys in roof; Left side, install chimney cricket to divert water around chimney. Includes new flashing for both chimneys. Install ridge vent along entire length of roof. Install 25 year gray, 3 tab Tamko shingles. Clean up and disposal of all waste and roofing materials. Caulk cracks in brick on rear and right side where window meets brick. Seal electrical cable entry point. Flexible caulk will not match mortar or brick but will be matched as close as possible.

Richard C.
Stafford, VA
November 15, 2021

Inside the home, remove the batter fiberglass insulation from the indicated rim joists in the living room. Spray foam the rim joists with 2 inches of closed cell spray foam. Spray foam the elbow of the supply trunk line with closed cell spray foam. From the exterior of the home, remove the indicated section of siding in the right side of the home (will only be from the first floor to the basement area. Remove the celotex board and batted fiberglass insulation covering the supply trunk line. Spray foam the supply trunk line with closed cell spray foam. Re install the existing fiberglass insulation and the celotex board. (If the celotex board is damaged in the process summit will replace at $50 additional per section) Tape the seams to prevent air penetration. Install a tyvek in the area of siding that was removed. Re install the siding as best as possible

Todd H.
Ashburn, VA
November 13, 2021

Remove one way metal trap. Fix hole with plywood or metal underlayment and shingles - best match due to age of existing shingles may not match exactly.

Luis M.
Arlington, VA
November 13, 2021

Remove the indicated section of shingles and plywood located on the front right dormer window. Install new flashing, ice/water shield, plywood, and shingles to match existing as best as possible. No guarantee to fully match. (Three tab weather wood).

Joe J.
Spotsylvania Courthouse, VA
November 13, 2021

Cut existing hole larger in order to access attic over the garage, hole is located in rear left corner. After insulation is installed patch hole which is approximately a 2‘ x 2‘ with drywall mud and sand only. Attic to have baffles installed for area of coverage 640 ft.² on front and rear at soffit line, blowing over attic r38 cellulose insulation for better energy efficiency. Pull up batted insulation and blow under it and then place batted insulation back on top.

Alissa T.
Fredericksburg, VA
November 12, 2021

Install blown in insulation in area above garage. Approx 400 sqft. To current code. Add insulation in attic above living space to existing to bring to current code throughout.

Iain C.
McLean, VA
November 11, 2021

Remove old blown insulation add 14 inches of cellulose only over laundry room. Access is in garage customer does not want entire attic insulated.

Jennifer S.
Alexandria, VA
November 10, 2021

Install GrateDrain system along rear wall from left inside doorway to right side edge of fireplace. Install Flexiflange and drill weep holes in the block pockets along entire length, back flush port be installed at the beginning of the run to permit servicing necessary. the customer may install flooring over the flush port but it is requested that it be left in a state that permits easy access. Install FastSump with liner in left corner of basement with high water alarm and clear check valve. Discharge line will be run up wall high enough to facilitate check valve installation then turn to run behind drywall to exit foundation on left side. Customer will install box to hid appearance of sump liner. Drywall will need to be removed where pipe runs up wall. Run discharge line under surface/under fence near landscape timber into flush mounted drain box. Customer will install dedicated electrical receptacle. Floor will be covered with high strength concrete when finished. Customer may install flooring after a minimum of 24 hours.

Mark Z.
Montclair, VA
November 5, 2021

Remove old blown in fiberglass insulation and animal feces. Sterifab entire attic space to disinfect. Install baffles at the soffit lines and around the entry point. Air seal gaps and conduit lines with spray foam insulation. Blow in new cellulose insulation to R49 (14 inches). Remove old attic fan and replace with new attic fan with thermostat. Install a roof vent guard to prevent entry of animals into the attic space.

Murray L.
Triangle, VA
November 5, 2021

Three separate attic spaces. Existing blown and batted insulation is inadequate per current building codes. Apply 5 inches of blown cellulose to all three attic spaces with baffles around 2 hatch entries in main portion of home. No insulation around and under air handler and walkway to air handler. In garage space insulate living space and include 8 light can covers. Remove any loose debris prior to work being completed in each space. This will bring the insulation value back up to R38.

George A.
McLean, VA
November 4, 2021

Remove all accessible insulation in attic space. Install baffles at soffit line that are missing and around hvac. Install attic tent over entrance. Air seal with closed cell spray foam any crack, gap, and conduit line. Blow in new cellulose insulation to R49 (14 inches). Blow over existing insulation to reach levels of 14 inches.

Ennis S.
Fredericksburg, VA
November 4, 2021

Removal of insulation to include droppings in attic, disinfect attic to kill any bacteria, parasites, or fleas. Blow in r38 cellulose insulation to current standard. Note walk boards in attic to be pulled up and put back down during the cleanup process.

Elizabeth H.
Arlington, VA
November 1, 2021

Remove all insulation. Disinfect entire attic and treat with mildew side and fungicide. Weatherstrip and use the zipper seal for attic hatch with ladder. Install baffles to keep insulation in place. Air seal any gaps, cracks or crevices with insulating foam. Blow in all new cellulose insulation to a depth of 14 inches. R49. Install wood platform in attic, above insulation, approximately 1” to 4” above insulation. About 28 feet long and 3 feet wide. Install two stainless steel heavy gauge screens over louver vents on each side of the home. This price is dependent upon this work being done with the crew was present for other work. This work would cost $650 if done alone. The point of this is to prevent rodent or raccoon entry into an attic with a nice new clean insulated surface Install radiant barrier on attic rafters on both sides of this roof. This will reflect much of the suns heat and prevent it from heating the air in the attic. Remove old and Install new ceiling fans that are supplied by the customer Install bathroom vents and fans in both bathrooms, these are to vent through the roof and one roof penetration. One will be operated by a switch which turns on the light and the fan at the same time, the other will have a separate switch. Broan quiet fans to be installed.

Page: 1 2 3 4 5 6 >> 
Total: 273

Our Affiliates
    Expertise Best Roofers in Fairfax 2018 logo Accredited Business logo

Testimonials