Repair gap at brick/ trim edge of attic gable with heavy gauge stainless steel screen, caulk, and mortar. Place plywood over opening on right front and cover with metal to prevent chewing through. Remove all insulation from attic. Disinfect the entire attic with a mildew killing, fungus killing agent. Install …

Install a 223 vent for the two bathrooms on the front side of the home. Old exhaust pipes will be removed and new insulated duct work will be installed. Remove the old attic fan and install a new attic fan with a thermostat. Install a roof vent guard over the attic …

Remove all insulation and debris and clean droppings from mice, bats owls and squirrels. Disinfect entire attic. Install baffles to keep insulation in place. Air seal all cracks and crevices and penetrations from wiring, plumbing, and hvac. Weatherstrip attic ladder hatch. Blow in all new cellulose insulation to a depth …

Blow in approximately 13-14” of cellulose insulation on top of the original flat roof in the attic (a gable roof has been built over the original roof). 13” of cellulose will provide an Insulation value of R49 (current code).Install foam board insulation on the attic access hatch and weather stripping …

Install can light covers over all recess lights and spray foam around the edge of the can light cover. Blow in new cellulose insulation to R38 (11 inches) in the attic space. Install rulers to show depth of the insulation. Baffle around the entry point.

Drill out in between floor joist in ceiling of garage and fill pack with cellulose insulation plug holes mud and sand after fill packing insulation for better energy efficiency of master bedroom. Spray foam two sides of vaulted ceiling located with in attic with 2 inches for better energy efficiency of …

Move around the insulation and air seal gaps and conduit lines with spray foam. Install can light cover over the recess light. Insulate the entry point and install weather stripping. Install new baffles at the soffit line and around the entry point. Blow over existing insulation with 10 inches of cellulose …

Rake over attic to level insulation and blow in or 19 fiberglass insulation color pink to existing to better insulate and provide energy efficiency to home. Plug holes in ceiling of garage with cock or spray foam so insulation doesn’t fall through wire penetration points and blow over our 38 blown …

Remove all the blown in/batted fiberglass insulation and fecal matter. Sterifab to disinfect and treat for mites, lice, and bacteria. Install baffles at the soffit lines and around the entry point. Install weather stripping at the entry point and insulate the entry door with foam board insulation. Air seal …

Remove all batted and blown in insulation from the attic space. Air seal with spray foam any crack, gap, and conduit line leading from the conditioned space to the attic space for better energy efficiency, seal out areas for mice as well. Install weather stripping around entry point and insulate …

Remove the flashing and section of shingles around the chimney. Replace one section of damaged plywood on then backside. Check the front side of the chimney wood for damage and replace if needed. Install new ice/water shield, shingles to match existing as best as possible (Tamko three tab antique …

Remove screen from within attic right gable vent to access nesting and droppings ,remove visible droppings and nesting under gable vent inside of attic to include disinfect treatment of entire attic to kill any bacteria, fleas, or parasites. Deodorize attic for any smell of urine. Replace right gable vent with …

Remove birds nesting to include droppings inside of vent on left-hand side of home and wipe siding of bird droppings, disinfect event for any bird mites or parasites. Install one white bird guard over vent to prevent bird from entering entering.

Remove squirrel nesting from the soffit lines. Install baffles at the soffit lines and around the entry point. Move insulation as best as possible to air seal gaps and conduit lines. Sterifab entire attic space to disinfect. Blow over existing insulation with cellulose insulation to reach 14 inches (10 inches will be …

Replace rig board one upper rear left section of home to include wrapping with white metal and ceiling to brick to prevent squirrels from re-entering. Install RVG on attic fan or a roof where squirrels are pushing it into your mesh to enter attic. One-way exit to be installed at …