Supply trunk in garage attic is leaking some air and condensation was noted in places. Apply closed cell foam to 20 LF of supply duct to air seal and insulate. In cavity where supply and return trunks pass into living space plus area outside of the chase, apply cellulose to insulate …

Remove damaged section of shingles and plywood. Install new plywood, 2×4, and shingles to match existing as best as possible. Tamko three tab antique slate.

Install bathroom vents and fans in both bathrooms, these are to vent through the roof and one roof penetration. One will be operated by a switch which turns on the light and the fan at the same time, the other will have a separate switch. Broan quiet fans to be …

Remove section of the ridge vent and two sections of the shingles and the plywood. Install a new metal ridge vent on indicated section to include the new plywood, ice/water shield, and shingles to match existing three tab as best as possible.

Clean out all debris from the gutters. Install Evelyn’s leaf solutions on all the gutters on the home. Will be secured to the lip of the gutter. Ends of the leaf solutions will be capped with white metal.

Existing roof past end of life. Some damaged decking noted as well. Tarp covering portion of roof. Ventilation is non existent and roof fan is non functioning. Tear off existing shingles and underlayment. Remove roof fan and discard. Inspect and replace up to 5 sheets of decking. Will need to verify …

Inside the home, remove the batter fiberglass insulation from the indicated rim joists in the living room. Spray foam the rim joists with 2 inches of closed cell spray foam. Spray foam the elbow of the supply trunk line with closed cell spray foam. From the exterior of the home, remove …

Cut existing hole larger in order to access attic over the garage, hole is located in rear left corner. After insulation is installed patch hole which is approximately a 2‘ x 2‘ with drywall mud and sand only. Attic to have baffles installed for area of coverage 640 ft.² on front and rear …

Remove the indicated section of shingles and plywood located on the front right dormer window. Install new flashing, ice/water shield, plywood, and shingles to match existing as best as possible. No guarantee to fully match. (Three tab weather wood).

Remove one way metal trap. Fix hole with plywood or metal underlayment and shingles – best match due to age of existing shingles may not match exactly.

Install blown in insulation in area above garage. Approx 400 sqft. To current code. Add insulation in attic above living space to existing to bring to current code throughout.

Remove old blown insulation add 14 inches of cellulose only over laundry room. Access is in garage customer does not want entire attic insulated.

Install GrateDrain system along rear wall from left inside doorway to right side edge of fireplace. Install Flexiflange and drill weep holes in the block pockets along entire length, back flush port be installed at the beginning of the run to permit servicing necessary. the customer may install flooring over …

Three separate attic spaces. Existing blown and batted insulation is inadequate per current building codes. Apply 5 inches of blown cellulose to all three attic spaces with baffles around 2 hatch entries in main portion of home. No insulation around and under air handler and walkway to air handler. In garage space …

Remove old blown in fiberglass insulation and animal feces. Sterifab entire attic space to disinfect. Install baffles at the soffit lines and around the entry point. Air seal gaps and conduit lines with spray foam insulation. Blow in new cellulose insulation to R49 (14 inches). Remove old attic fan and replace …